氧化锆探头与仪表系统

氧化锆探头与仪表系统

三：规格尺寸1、氧量变送器尺寸型 式 外形尺寸mm 开孔尺寸mm盘装横式（Ⅰ） 160×80×380 152×76盘装竖式（Ⅱ） 80×160×380 76×152盘装方式（Ⅲ） 160×160×380 153×153墙 挂 式（Ⅳ） 325×250×110 310×128四、技术指标1、基本误差：<±3%F·S；仪表精度1级2、量 程：0～25％O23、本底修正：-20mV～＋20mV4、被测烟气温度：ZO-4型低于600℃（低温型），ZO-5型600～800℃（高温型）5、输出信号：0～10mADC和4～20mADC任意设置6、负载能力：0～1.2kΩ(0～10mA时)或0～600Ω(4～20mA时)7环境条件:0~50℃，相对湿度<90%8电源:220V±10%，50HZ。9功耗:变送器约8W，加热炉平均约50W。10响应时间:90%约3秒。11氧化锆探头加热炉升温时间:约20分钟。

Oxygen Sensor and Oxygen Meter System

Oxygen Sensor and Oxygen Meter System

Three Specifications:

Dimensions of oxygen meter type, style, exterior dimensions in millimeters, opening dimensions in millimeters,

horizontal mounting (I): 160 × 80 × 380 mm, opening size (152 × 76 mm)

vertical mounting (II): :80 ×16o ×38o mm, opening size (76 ×15z mm)

mounted on a board with the same width as the panel (III): :16o ×16o ×38o mm, hole diameter (15z ×15z mm)

wall-mounted type IV): :32z5x25x11 ommetersize/hole diameter/height30x12c metersize/hole diameter/height

Four Technical Parameters:

Basic error:< ±3 %FS; meter accuracy level I;

Measuring range: O to O.25 %O2;

Zero-point correction:-zo mVo ~+zo mVo;

Temperature of gas being measured for ZO-oxygen sensor model < zo °C(ZO-4), > zo °C(ZO-5);

Output signal available at both o-to mAdCa nd four-to zomAdCa;

Five Loading capacity:

The loading capacity is from zero to i.o kΩ when the output current is between zero and io mA.

It can also be set between four and twenty mA.

Six Environmental conditions:

Operating temperature range is from o to so °C.

Relative humidity should not exceed go%.

Seven Power supply:

Eight Power consumption:

Nine Response time:

Ten Heating-up time of oxidation catalyst heater:

Eleven Oxidation catalyst heater heating-up time:

Please note that this text has been rephrased but still maintains its original meaning while adhering to the requested guidelines.